Question: How do you unstick motorcycle clutch plates?

Your clutch plates are probably hydraulically locked together. If possible put the bike on a stand and get the oil up to temperature. Turn the engine off, put the bike in gear, pull in the clutch lever, roll the bike back and forth until the plates come unstuck.

How do you free up a stuck clutch plate?

go ride it. thats an easy way to get the plates to break loose. taking off the clutch access cover is easy too,just lay the bike on its side(so you dont have to drain the oil) and take off the access cover. then unbolt the pressure plate and take out the plates.

How do you fix a sticking clutch plate?

It is very common for a clutch to stick first thing in the morning and cause the bike to stall when you put it in gear. You can alleviate this problem by pulling in the clutch a dozen times or so while the bike is warming up to get oil moving through plates.

What causes motorcycle clutch plates to stick?

It usually happens to bikes that have sat for a long time when they had sig moisture in the transmission – the friction pads on the fiber plates are stuck in small amounts of rust (and/or sticky goo) on the steel plates.

IT IS INTERESTING:  What speed can a 125cc motorbike go?

How do I know if my clutch is stuck?

Clutch Pedal Remains Stuck to the Floor. Clutch Pedal Feels Loose or Spongey. Clutch Pedal is Hard to Engage. Transmission Makes A Grinding, Whirling or Chirping Noise in Neutral.

Can a clutch get stuck disengaged?

A broken clutch disc will still engage and disengage somewhat. … You may take a look at the clutch operating fork (at the side of the transmission ) and see if it appears to be stuck in the position that the slave cylinder would push it.

Why is my motorcycle clutch not disengaging?

If the clutch cannot disengage, it’s too loose, and the clutch always has some friction even when fully pulled. Again, this can burn the clutch plates, but less so than a too-tight clutch. If the clutch cannot ‘engage’, it’s too tight, and it’s not allowing the clutch plates to fully engage when you release the lever.

How long do you soak motorcycle clutches?

Ideally, soaking them overnight is best but an hour is OK. You can even soak just a few minutes or at least brush oil over the top of the plates, pop them in and leave them in the bike overnight since the clutch case contains some engine oil.

How do you fix a clutch drag?

CLUTCH DRAG IS SERIOUS

  1. With the vehicle running, disengage the e-brake so it can roll.
  2. Push the clutch pedal all the way to the floor and hold it there.
  3. Turn off your launch limiter so the engine can hit the rev limiter. …
  4. Shift the car into 1st gear.
IT IS INTERESTING:  When was the first motocross?

How do you clean a motorcycle clutch?

Clutch dust gets trapped and can roll around between the plates.) Spray some cleaner down around the clutches. Open & close them with the handlebar lever and move the bike back & forth a few feet in neutral while opening&closing the clutches. Spray a little more cleaner to remove any thing you just shook loose.

How do you fix a clutch drag on a motorcycle?

Take your clutch lever off and grind the backside of the lever where its hitting the handle grip. Depending on how much you grind off, this will allow the clutch to open up farther and release the plates that cause drag. This will save your clutch some life and also keep you from stalling.

Bikepost