How do you fix a sticky throttle on a motorcycle?

What causes a motorcycle throttle to stick?

A sticky throttle could be caused by worn cables, lack of lubrication in the cables or the cable getting bound up somewhere in the mechanism. Or it can be caused by an issue with the carburetor or EFI. … If the screws in the throttle housing are too tight it could cause the cable to stick.

How do you deal with a sticky throttle?

When the motorcycle throttle sticks to acceleration mode, pull on the clutch, shift to neutral, and turn off the motorcycle. Do not turn on the motorcycle until the issue is resolved. If the throttle sticks to the closed position, turn off the motorcycle and inspect and clean the throttle and the throttle cable.

Can I use wd40 to lube throttle cable?

WD 40 is a great quick and dirty solution to sticky cables. It flows great and flushes out that damn cable lube that gums up and attracts dirt. Use it regularly to keep moisture and dirt out.

Should motorcycle throttle snap back?

Registered. Make sure your throttle isn’t slid onto the handlebar too far. If the inside of the rubber hand grip is tight against the end of the handlebar, it will want to hang open and not snap back.

IT IS INTERESTING:  Is riding a motorcycle a good workout?

Why is my throttle sticking on my dirtbike?

Debris can get caught between the throttle tube and the handlebar, and cause it to stick. Another culprit happens at the other end of the throttle cable. … If you’ve changed your grips recently, a little too much glue can get between the handlebar and the throttle tube, and that can cause problems as well.

How do you lubricate a gas pedal?

Lubricate metal-to-metal points with clean engine oil. Some cars have accelerator pedals pivoted at the floor. Lift the carpet to avoid marking it, then lubricate the metal hinge with clean engine oil. If a floor-pivoted pedal is fixed to a shaft that operates through a metal tube, lubricate the inside of the tube.

What is the best lubricant for motorcycle cables?

Choosing The Correct Lubricant

Some cables have a slick inner sheath that will gum up if exposed to solvents or harsh chemicals, so do NOT use WD-40 or any other type of penetrating oil. Regular motor oil works great if you don’t have an appropriate aerosol product.

Should I grease my throttle tube?

I wouldn’t lube the throttle tube. When clean and when there’s nothing rubbing on the tube it should work fine. Lubing it may make it turn better but will require frequent cleaning and relubing of the tube.

Bikepost