# Frequent question: What volts should a motorcycle battery read?

Contents

A fully charged battery should read approximately 12.6VDC. If it reads at or below 12VDC, recharge the battery. Allow battery to rest and test again. A battery that has been fully charged, rested, and tests between 12 and 12.6VDC might start the motorcycle, but it’s not holding a full charge.

## What should a healthy motorcycle battery read?

A healthy 12 volt motorcycle battery should maintain a range from 9.5 – 10.5 volts under the load, for a good 30 seconds straight. If the battery begins to hold and then steadily declines, there is a problem. If the voltage drops to 0 volts, there is a problem. We call this, the open cell.

## What voltage should a 12 volt battery read when fully charged?

A fully charged battery will typically display a voltmeter reading of about 12.6 to 12.8 volts. If your voltmeter is showing a voltage anywhere between 12.4 and 12.8, that means your battery is in good shape.

## How many volts should a good battery show?

Check the voltage.

IT IS INTERESTING:  Best answer: How much does a Harley Davidson oil change cost?

A good car battery should read 12.4-12.9 volts when the car is off. Anything lower doesn’t necessarily mean the battery is bad. Your car’s electrical system may have drained it, or there may be an issue with your alternator.

## How do I check for a battery drain on my motorcycle?

The way to check is to remove the negative battery cable and place your volt-ohm meter in the current (amps) mode. With the key off, place the meters leads between the negative cable and the battery’s negative terminal. The current draw should be zero, but a small drain on the order of a few milliamps is acceptable.

## At what voltage is a 12 volt battery considered dead?

For a 12 volt, leadacid battery, the voltage measured between these two points should be between 11 and 13 volts. The closer the voltage is to 13 volts, the closer the battery is to being fully charged. The closer the voltage is to 11 volts, the closer the battery is to being “dead”.

## Is 11.9 volts enough to start a car?

A flat battery can show 12 volts , but not be good enough to start a car . … 11.9v indicates the battery is completely discharged. Anything under 12.2v means the battery is in a state of discharge, and a healthy battery should show 12.6v in a static state.

## How do I know when my 12 volt battery is fully charged?

A fully-charged 12-volt battery, allowed to “rest” for a few hours (or days) with no load being drawn from it (or charge going to it), will balance out its charge and measure about 12.6 volts between terminals. When a battery reads only 12 volts under the above conditions, it’s almost fully depleted.

IT IS INTERESTING:  What do I need to start riding a motorcycle?

## Why do motorcycle batteries die so fast?

All too often, motorcycle batteries die young, murdered by neglect. Dehydration, improper charging, and a slow discharge during storage all shorten a battery’s life. … To prevent these draws from killing your battery, you could disconnect the battery, but even if there is no load on them, batteries self-discharge.

## What is the average life of a motorcycle battery?

Battery manufacturers agree that on average, a motorcycle battery should last 48 months, yet most of us are lucky to get half of that, and in most cases the battery’s premature death can be chalked up to a lack of maintenance.

## Can a completely dead motorcycle battery be recharged?

If you do have a dead battery, you can recharge it with a battery charger (this is preferred), or by jumpstarting your bike with another bike or a car. … Once you get the bike running, make sure to ride it for a good while in order to get it fully charged again.

## Is 12.3 volts a good battery?

An open circuit voltage check that yields 12.3 volts means that the battery is at a state of 50%-75% charged. The battery should read at least 12.6 volts. You’ll get more accurate results if you do a load test. Re: How low does Car Battery have to measure before it is good.

## How do you test if a battery is good?

Use a third-party app to test an Android battery.

Then use your phone as you normally would for at least a day. After a day, open the app to view information on the health of your battery. You’ll get more accurate information after using the app for weeks or even months.

IT IS INTERESTING:  Question: Is it cheaper to build a motorcycle or buy one?