Your question: How do I maintain my front suspension on my bike?

How do I lubricate my front bike suspension?

Keeping oil in and dirt out

To encourage the oil to lubricate the upper bushes and the seals in the fork leg, it is helpful to turn the fork upside down to let the lubrication run down. Turn your bike upside down and allow 20 minutes for the oil to run down into the seals.

How do you lubricate bike shocks?

With the syringe go round the seals gently applying some oil, use the same oil that is inside your forks or you can use Finish Line Shock oil if you have none spare. Next take another cloth and add some more oil to the cloth then gently wipe down the stantions to give them a light coating.

How do you maintain suspension?

What You Can Do at Home

  1. Clean Your Fork and Shock After Every Ride. Completely clean your fork and rear shock after each and every ride. …
  2. Turn Your Bike Upside Down. You can also turn your bike upside down now and then for about 20 minutes at a time. …
  3. Install a Mudguard. …
  4. Inspect Your Stanchions Regularly.


Can I use WD40 on my bike suspension?

Yes you can use WD 40 on your chain…. The big problem is getting the WD 40 on the rubber seals in the rear wheel bearings, suspension bearings, and the BB bearings. The WD 40 can really clean up a chain…it is too light to stick around long enough to act as a good lubricant…

IT IS INTERESTING:  Quick Answer: Can you ride an electric bike like a normal bike?

What is the best lubricant for bicycle chains?

Best bike chain lubes – our picks

  • Rock N Roll Gold. …
  • Silca Super Secret Chain Lube. …
  • Green Oil Wet Lube. …
  • Finish Line Wet. …
  • CeramicSpeed UFO Ceramic lube. …
  • Tru Tension All Weather. …
  • Molten Speedwax. Wax chains take a bit of extra work, but are well worth the effort. …
  • Squirt chain lube. High-performance, wax-based lube.


Can I use 3 in 1 oil on my bike chain?

Lubricate it

Using WD40 or 3-in-1 oil may seem pudent but it won’t things running smoothly and will cause dirt and grime to stick to the chain and prematurely wear.

What oil should I use to lubricate my bike chain?

Lube Them: Wipe off any built-up grime on your derailleur pulleys with a clean rag and degreaser. Then apply a small drop of lube, such as Phil Wood Tenacious Oil, to the bearings at the center of the pulley.

What are signs of suspension problems?

Suspension Warning Signs

  • Continued bouncing after hitting bumps or a dipping when braking.
  • A drifting or pulling to one side when turning corners.
  • One side of the parked car sitting lower than the other side.
  • Difficult steering.
  • Unusually bumpy rides.

How do you increase suspension?

For anyone who wonders how to improve the suspension on a truck, you can do it easily by just following the steps covered in this article:

  1. Upgrade the shocks.
  2. Reinforce the leaf springs.
  3. Switch to bigger wheels.
  4. Add a torsion bar.
  5. Use a lift kit.
  6. Add strut braces.
  7. Tune up the suspension.