Why is my suspension so stiff MTB?

Preload is HOW STIFF is the suspension, and it’s related to how much force must be applied to compress it. More preload means you need more force (apply more weight) to compress the fork by a given distance or travel. … If you feel that it takes too much force to compress your fork, it means you have too much preload.

How stiff should mountain bike suspension be?

Whether air or coil, a shock should generally be set between 25- and 30-percent sag. To set sag (on a common air shock), start by pushing the o-ring to the top of the stroke and then carefully sit on your bike.

Can you use wd40 on bike suspension?

Yes you can use WD 40 on your chain…. The big problem is getting the WD 40 on the rubber seals in the rear wheel bearings, suspension bearings, and the BB bearings. The WD 40 can really clean up a chain…it is too light to stick around long enough to act as a good lubricant…

Is it bad to bottom out suspension MTB?

You should be using all of your travel on every ride within reason – you probably shouldn’t set your suspension up to use all the travel on a flat XC ride. Harsh bottom-outs are a bad thing though and should be avoided. … Some even increase damping on the end travel. Meaning, in most cases, bottom out can happen.

IT IS INTERESTING:  Is it harder to cycle in the cold?

When should I lock my mountain bike suspension?

With a lockout fork a full suspension system can be utilized when riding downhill and on rough terrain. With the flip of a single switch the suspension can be made more rigid for riding uphill or on pavement.

Is 120mm travel enough for trail?

In addition, you’re not likely to notice much difference between a 120mm, 130mm, and 140mm fork. Honesty, a 120mm fork is enough travel for most Trail riders. Longer travel doesn’t necessarily mean better.

How do I make my Fox shocks softer?

When you decrease rebound damping by turning the adjustment knob counter-clockwise, you allow the shock to extend faster. It feels softer, more supple, and livelier. When you increase rebound damping by turning the adjustment knob clockwise, you make the shock extend slower.

What PSI should rear shocks be?

The Fox website says the safe operating range is 50 to 300 PSI.

Can you soften bike suspension?

If it has a spring inside, the real way to soften it is to buy a new spring and throw that in. But you can soften it up a bit with some basic tuning. To start, change your rebound to the fastest setting. The rebound adjustment should be on the bottom of your lowers on your fork.

Can you convert a coil fork to air?

There are forks that use a cartridge system – for example, Ohlins RXF forks. This means the air spring is a complete cartridge, that doesn’t rely on the surface of the stanchion for sealing. These forks can be changed from coil to air very easily, without any problems.

IT IS INTERESTING:  You asked: Why KTM bikes are costly?

How do you calculate suspension sag?

% Sag = (Stroke Used) / (Total Stroke Length) * (100 %)

  1. The Stroke Used is the amount of suspension stroke used while you are on your bike in a static riding position.
  2. The Total Stroke Length is the length of the shock shaft that is available to be compressed.

12.09.2017

Bikepost