Another ballpark method for checking chain wear is by measuring it with a ruler. Pick a rivet and line it up at the zero mark. Count 24 more rivets and your last rivet should be at the 12″ mark of your ruler. If it is off by more than 1/16″ your chain is stretched to the point of replacement.
Do bike chains stretch?
Do bicycle chains really stretch? The short answer is no, however they do wear in such a way as to cause their maximum length to increase. Mechanics usually refer to this as chain “stretch.” It is the sign of a worn out chain that should be replaced.
What causes a bicycle chain to stretch?
Chain wear is commonly referred to as ‘chain stretch’, because the chain’s pitch grows in length as it wears. This is the most important type of chain wear, and the growth comes from the bushings wearing with the chain pins. Overtime, the inner diameter of these bushings increase and the pins groove out.
How do you fix a stretched bike chain?
How to Tighten a Bike Chain
- Loosen your tire. Loosen the bolts that hold your rear tire.
- Pull back the tire. Move the tire back until the chain starts to tighten.
- Find the appropriate tension.
Can I use WD40 on bike chain?
Can I use WD-40 to lube my bicycle chain? No. You should never use WD40 as chain lubricant since WD-40 is NOT a true lubricant since it’s primary use is as a solvent or rust dissolver.
How often should I lube my bike chain?
If you are a frequent rider, using your bike several times throughout the week, your bicycle will benefit from a regular cleaning and lubrication of the drive chain. Bicycle Tutor recommends cleaning and lubricating your bike’s drive chain at least once every month to maintain optimal performance and protection.
How long does a bicycle chain last?
A chain can last anywhere from about 500 miles to 5000, depending on the quality of the chain, the sprockets, how the bike is ridden, and the maintenance.
How many miles does a bicycle chain last?
Replacing your chain regularly can prolong the life of your drivetrain. Most mechanics agree that you should replace your chain about every 2,000 to 3,000 miles, depending on your riding style. Many Tour De France riders wear out two or even three chains on their primary bike over the course of the three-week race.
What happens if bike chain is loose?
You may experience the following if the chain is too loose: * Creates unusual jarring noises when the chain runs over the sprockets. * Chances of getting the chain out of the sprocket is high. * Clanging motion along with noise whenever the throttle is opened.
What happens if your bike chain is too loose?
When it’s loose, the rate of power transfer drops, and you aren’t able to propel the bike forward. A bike chain can fall off completely, but oftentimes it only becomes loose. If it isn’t too loose, you can keep cycling until your destination and then tighten it.
What happens if bike chain is tight?
When a motorcycle chain is too tight, it’ll put stress on several components of the bike and cause the sprockets to wear faster, make the engine work harder, and cause the suspension to be tight and uncomfortable. Ultimately, a tight chain on a motorcycle may break leaving you with no power.
Should you replace a rusty bike chain?
If your bike chain is severely rusted, replacing it entirely may be best for the health of your bike. Imperfections in severely deteriorated chains can damage other parts of your drivetrain. … After the chain is clean, you’ll only need to reattach and lubricate it before you’re ready to ride.
Do I need to oil my bike chain?
To get the most life from a chain, you should regularly clean and lubricating your chain. Clean your chain every few rides, or directly after any muddy rides. You should then apply a suitable lubricant and ensure it’s lubed correctly for each ride.